Note: To use PoE passthrough on the Secondary port, a 24V, 1A PoE adapter is required. (NanoStationM2/M3/M5 only) This 10/100 Ethernet port is used for bridging and supports software-configurable PoE passthrough. In airOS®, you can modify the threshold values for the wireless signal strength LEDs on the Advanced tab under Signal LED Thresholds. (NanoStation M2/M3/M5 only) The LED will light steady green when an active Ethernet connection is made to the Secondary port and flash when there is activity. The LED will light steady green when an active Ethernet connection is made to the Main/LAN port and flash when there is activity. The LED will light green when the device is connected to a power source. Hardware Overview NSM2/NSM3/NSM365/NSM5/locoM2/locoM5 The ETH-SP will absorb power surges and safely discharge them into the ground. We recommend that you use two Ethernet Surge Protectors, model ETH-SP, one near the NanoStation and the other at the entry point to the building. Surge protection should be used for all outdoor installations.For more details, visit ui.com/toughcable We recommend that you protect your networks from harmful outdoor environments and destructive ESD events with industrial-grade, shielded Ethernet cable from Ubiquiti. Shielded Category 5 (or above) cabling with drain wire should be used for all wired Ethernet connections and should be grounded through the AC ground of the PoE.The Antenna Gain and Output Power fields are provided to the professional installer to assist in meeting regulatory requirements. Installer Compliance Responsibilityĭevices must be professionally installed and it is the professional installer’s responsibility to make sure the device is operated within local country regulatory requirements. Setup using the UISP ™ app requires the U-Installer, sold separately. You can also manage your device using the Ubiquiti Internet Service Provider. For details, refer to the User Guide available at ui.com/download/airmax The airOS Configuration Interface will appear, allowing you to customize your settings as needed. You must agree to the Terms of Use to use the product. Enter ubnt in the Username and Password fields.Launch your web browser and type in the address field.Configure the Ethernet adapter on your host system with a static IP address on the 192.168.1.x subnet.Make sure that your host system is connected via Ethernet to the device.Verify connectivity in the airOS Configuration Interface. WARNING: The switch port must comply with the power specifications listed in this Quick Start Guide. * The Main port is labeled LAN on the NanoStationlocoM2/M5. Alternatively, the device may be reset remotely via a Reset button located on the bottom of the PoE adapter. To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the device is powered on. This 10/100 Ethernet port is used to connect the power and should be connected to the LAN and DHCP server.
0 Comments
Leave a Reply. |